YESSSSS. It’s taken so much work but yes! IT WORKS! Thanks for watching.

This is the actual working model of the cutaway series. The reversible cutaway model with stephenson valve gear working with the completely built cylinders. The cutaway cylinder in the other videos is visible on the table. This is just to prove to people that the engine will actually work when the cylinders are built just like in the demonstration model. This reversible engine uses everything seen in the three other videos except that the cylinders are finished. Thanks again to legokid900 for the reverse link dementions. This video was requested by RustyCarnahan and mindstormer398. Thanks for watching!

11hp Briggs horizontal engine startup – 5/27/10

Part 3 of my series of videos covering how I converted an old 90782 vertical axle lawn mower engine to a horizontal engine. In this video: Crankshaft

Honda GC160 5.0HP Horizontal Crankshaft Engine with two holes in the crankcase behind the flywheel.

This is some miscellaneous video that did not make the cut

Coming together and working well!

You wanna have air without a noisy compressor? Maybe here is the solution! For a normally DIYer no problem! Of course it’s cycle-friendly, eco-friendly and if the air is gone out, you can recharge it on a service station for nothing!!

Not sure what to do with the weber. last 2 serial number digits are 68, possible build in 1968?

Large model single cylinder horizontal stationary steam engine The engine runs well on 20 PSIG. air. Engine cylinder 2 Ins. Dia.. Stroke 3 Ins.Piston fitted with two rings. Water is circulated through the condenser copper cooling coils by an engine driven reciprocating pump.